ID 16c0:05e1 VOTI CDC-ACM class devices (modems)
ID 16c0:05dc VOTI shared ID for use with libusb
Potrzebuję zaprogramować Atmega32 po ISP (za pomocą któregoś z programatorów powyżej).
Ktoś podpowie tak to zrobić, krok po kroku? (zero doświadczeń z programowaniem za pomocą Comand Line Interface, sterownikami do programatorów w środowisku linux itp. Prośba o pomoc.
Zainstalowałem avrdude:
Kod: Zaznacz cały
root@raspberrypi:/home/pi# avrdude
Usage: avrdude [options]
Options:
-p <partno> Required. Specify AVR device.
-b <baudrate> Override RS-232 baud rate.
-B <bitclock> Specify JTAG/STK500v2 bit clock period (us).
-C <config-file> Specify location of configuration file.
-c <programmer> Specify programmer type.
-D Disable auto erase for flash memory
-i <delay> ISP Clock Delay [in microseconds]
-P <port> Specify connection port.
-F Override invalid signature check.
-e Perform a chip erase.
-O Perform RC oscillator calibration (see AVR053).
-U <memtype>:r|w|v:<filename>[:format]
Memory operation specification.
Multiple -U options are allowed, each request
is performed in the order specified.
-n Do not write anything to the device.
-V Do not verify.
-u Disable safemode, default when running from a script.
-s Silent safemode operation, will not ask you if
fuses should be changed back.
-t Enter terminal mode.
-E <exitspec>[,<exitspec>] List programmer exit specifications.
-x <extended_param> Pass <extended_param> to programmer.
-y Count # erase cycles in EEPROM.
-Y <number> Initialize erase cycle # in EEPROM.
-v Verbose output. -v -v for more.
-q Quell progress output. -q -q for less.
-? Display this usage.
avrdude version 5.11.1, URL: <http://savannah.nongnu.org/projects/avrdude/>
root@raspberrypi:/home/pi#
Dwa programatory wpięte i widziane przez system:
Kod: Zaznacz cały
root@raspberrypi:/home/pi# lsusb
Bus 001 Device 018: ID 16c0:05dc VOTI shared ID for use with libusb
Bus 001 Device 017: ID 16c0:05e1 VOTI CDC-ACM class devices (modems)
root@raspberrypi:/home/pi#